Black & Color Cartridges
1. Use adhesive tape to seal the outlet hole(s) in the base of the cartridge. A separate piece over each hole is recommended.
2. Attach the needle to the syringe and fill with the appropriate color ink.
3. Push needle through the label all the way into the cartridge of the correct filling hole. Very slowly inject ink into the sponge until the cartridge is full. (This will saturate the sponge with ink and refill the reservoir)
4. Use adhesive tape to seal the holes(s) made in the top label. Note: The cartridge will leak if the holes are not sealed properly.
Let the cartridge sit out in a sink for 5 min before reinserting
into printer to check for leakage.
5. Unused ink may be returned to the bottle. Rinse the syringe with water and dry between each color refill or store for further.
6. Reinsert the cartridge leaving the adhesive tape on the outlet hole(s) and run 1 - 3 cleaning cycles as per printer instructions. Note: If necessary leave cartridge in printer for up to 24 hours to allow the ink to flow to the print head.
NOTE: This time is greatly reduced if cartridge is refilled before it is completely empty.