- Put tape over Contact #1 as shown in the picture to the left.
Put the cartridge back into the printer with the tape still
stuck onto the cartridge.
- The printer will print out an alignment page. Once this has
completed, continue down to Step 3.
- After the printer has completed printing off the alignment
page, open the cover, remove the cartridge and place a piece of
tape over Contact #2 as shown in the picture to the left.
- Put the cartridge back into the printer. The printer will
print off another alignment page. After this page has been
printed, remove the cartridge from the printer, remove all tape
from both Contact #1 and #2. Reinsert the cartridge back into
the printer. Ink levels should now read full.
- If the process does not work for you, make sure that no
adhesive was left stuck to the contacts on the cartridge. Any
residue will keep the cartridge from working properly and may
cause the cartridge not to be recognized by the printer at all.
You may also try following the instructions for
This page developed by
Xrefill-
Ink Refill Kits
