Black & Color Cartridges
1. Cut label at joint between top and bottom cap of cartridge case.

2. Flip back bottom cap of cartridge.

3. Squeeze sides of cartridge case and carefully wiggle out mylar ink bag and pump assembly from the insert lock.

4. Remove rubber sealing plug (situated in the filling hole) with any sharp object. (Keep the plug, you will use it again).

5. Inject the ink through the filling hole into the mylar ink bag. (Do not insert the needle more than 1/2" into the bag or else the mylar ink bag may be punctured).

6. Fill with ink until ink appears at the bottom of the filling hole and then reseal by pushing back in the rubber plug. (Push in with the plug on the end of the screw and then remove the screw from the plug).

7. Remove the excess air from the mylar ink bag and pump assembly as follows:
A. Hold assembly at a 45° angle with outlet hole tube at the top.
B. Insert needle of empty injector (with plunger pushed in) into outlet hole tube.
C. Press and release pump several times which will expel air into the syringe.
D. Pull back the plunger on the syringe to remove any air from the outlet hole tube and then withdraw the needle.

8. Replace the mylar ink bag assembly into the cartridge case and clip the bottom back into position.

9. Install the cartridge back into printer.

TO RESET the chip in the cartridge follow this procedure:
Step 1: Using normal tape cover the the black bulb in the center of the bottom of the cartridge( located on the mylar bag).
Step 2: Give a little bit of a sag (dimple the tape into the cartridge a little ) this should fool the printer into thinking this is a new cartridge.
Step 3: Reset the cartridge. Or install as if it were a new cartridge


Note: Immediately refill any empty cartridges.

 

 

 

This page developed by Xrefill- Ink Refill Kits